Genuine Mercedes-Benz 190E Seat Belt

Mercedes-Benz 190E Seat Belt Parts and Q&A

• Belt & Retractor
  201-860-31-85
  Q: How should you inspect seat belts for safety and functionality in the petrol engine on Mercedes-Benz 190E?

  A:

  Look carefully at the seat belt webbing, particularly looking to see whether it has been cut or shows evidence of severe fraying or damage, and make sure you pull the belt out to the full extent (retraction-type belt) to check the full length of the webbing. Check and adjust the belt locking, so that when it is needed the lock and release properly; and when retractable, see that the retracting. Also, verify the safety of all available seat belt mountings and attachments without removing any interior trim or other elements in the car.
• Belt & Retractor
  201-860-32-85
  Q: How to remove the front and rear seat belts on Mercedes-Benz 190E?

  A:

  To remove the front seat belt, start by undoing the two lower retaining screws of the centre pillar trim panel. Swivel the seat belt rearwards, slide off the cap over the lower mounting bolt, and then undo the lower mounting bolt. Next, pull off the door rubber sealing weatherstrip around the centre pillar, move the centre pillar trim downwards to release the upper retaining clip, and remove the trim. Undo the upper guide retaining bolt and the inertia reel retaining bolt, then remove the belt. If the seat belt stalk needs to be removed, first take out the driver's or passenger's seat as applicable, hold the stalk, undo the retaining bolt on the side of the seat, and remove the stalk. For refitting, follow the reverse order of removal. For the rear seat belt, begin by removing the rear seat bench, then undo the bolt securing the seat belt mounting to the floor. Pull off the door rubber sealing weatherstrip around the trim panel on the rear pillar, carefully push off the trim panel clips at the front towards the centre of the car using a wedge, and push the trim panel upwards to remove it from the rear pillar. Remove the rear seat backrest, undo the upper guide retaining bolt on the rear pillar, unclip the sound-deadening material around the rear inertial reel, and undo the inertia reel retaining bolt to remove the seat belt from the car. If the stalks are to be renewed, undo the single bolt, remove the separating plate, and take out the relevant stalk. For refitting, follow the reverse order of removal.